USB-C is now the standard connector on every major mirrorless camera system — Sony, Canon, Nikon, Fujifilm, Hasselblad. But not every USB-C cable handles tethering. The connector is the same. The engineering behind it is not.
USB-C Tethering vs USB-C Charging: What's Different
- Signal integrity — passive cables at 5m+ lose signal quality. Active cables with built-in repeaters maintain 10Gbps across the full run.
- Connector retention — a tethering cable moves constantly. The connector needs to maintain contact under motion and vibration.
- Cable flexibility — a stiff cable creates port stress every time it's repositioned.
The Loloboo USB-C Tethering Cable
Built for 10Gbps USB 3.2 Gen 2. The camera end is angled at 90 degrees — the connector exits the port pointing down and back, not straight out. Under cable tension, the force runs along the cable body. The port is never under direct pull stress.
At 5 meters, a single built-in booster block actively amplifies the signal. At 10 meters, two repeater blocks maintain full 10Gbps performance across the entire length.
Camera Compatibility
- Sony — A7R V, A7 IV, A1, FX3, FX6
- Canon — EOS R5, R5 C, R3, R6 Mark II
- Nikon — Z9, Z8, Z7 II, Z6 III
- Fujifilm — GFX 100S II, GFX 50S II, X-T5, X-H2S
- Hasselblad — X2D 100C, CFV 100C
- Phase One — IQ4 series
5m vs 10m: Which Length?
5m (single booster) — ideal for most studio setups. Enough slack to move freely around a subject.
10m (dual repeaters) — for larger studios, warehouse shoots, or on-location work where the tethering station needs to be far from the shooting position.
0 Kommentare